eskal 


It is important for the bending of LSG-panes for the automotive industry that the panes do not have any optical failures after the lamination process. For this reason the panes which are designated for bending as pairs or as multilayer get oncemore soften in the bending oven at temperatures between 500°C and 650°C.

For this bending process, a specific interleaving powder is applied to avoid that the panes stick together and to enable the separating of the sheets again after bending.

It is important to use a product which supports an almost regular distance between the single sheets. The powder should be free of coarse particles as such would result in (interfering) lenses.

Our interleaving powder series eskal – based on the temperature resistant calicum carbonate – is established worldwide as standard.

The powders of the series eskal have an excellent particle size distribution and fluidity. The particles adhere reliably on the glass surface and can be washed-off without any problems after the bending process.

Especially in the dry application with EPS-Application systems, our powder eskal has proven itsself. But it is suitable for wet application as well.

Due to an extremely narrow particle size distribution (fine and coarse particles are almost eleminated) an regular distance between the complete glass surface is ensured. This reduces the failure rate because of optical failures.

 
our products:

eskal 15         the standard product with an average particle size
                    distribution of approx. 18 µm

eskal 14         our optimized powder, based on eskal 15 but with a 
                    further reduction of coarse particles

eskal 10         a fine variant where eskal 15 is too coarse for the 
                    application, average particle size approx. 10 µm

eskal 500 
                   • the finest powder type, approx. 5 µm
                   • especially suitable for bigger bending 
                     radiuses or multilayer bending for instance for
                     bullet proof glass
                   • because of the fineness the powder has a
                     reduced flowing property which may be difficult
                     for application with air powdering systems
                   • It is suitable for wet application.
 
eskal 500plus  
                   • the same basis as eskal 500
                   • because of a special treatment with significantly 
                     improved fluidity
                   • excellently suitable for air powdering systems
                   • will NOT work with wet application.